DiecastXchange Forum banner
1 - 4 of 4 Posts
G

·
Discussion Starter · #1 ·
Hi,

I just want to know how to open up the AUTOart Porsche 996. I can't seem to find the screws and I'm scared of breaking any plastic parts. Please give me some pointers.

Thanks
RS
 
G

·
Discussion Starter · #2 ·
The AUTOart Porsche models are hard to work with just for this fact. There are regular screws 4 in total and then there are some really small screws, I believe there are 2-4 depending on which model.

You will see some reall small holes on the undercarriage and thats where they are located. I have tried the smallest of smallest screw drivers and could budge them without stripping them :badidea
 

·
Registered
Joined
·
38 Posts
AUTOart Porsche's are not very hard at all to disassemble,there are 6 screws holding the chassis together. 1 at each corner and 2 smaller ones at the rear wheels,these are the most difficult,just remove the rear tires and use a good small headed screwdriver.hope this helps you.If not let me know and I'll try and help you some more

911boy
 
1 - 4 of 4 Posts
Top