DiecastXchange Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
1,295 Posts
Discussion Starter · #1 ·
a long time ago i took on this commission build for Alex, (sorry again that it took so long)

i modded it to have some spinning work S1 in 18" with alloy barrels and a gun metal center.

and alex also wanted a TRD spoiler lip. i used a RB V2 spoiler for it

Original V2 spoiler:

























 

·
Administrator
Joined
·
6,960 Posts
the chassis on the Century Dragon GT86 is made of metal, and is hard to work on. i sent it to Hurryfast so the offroad stance could be fixed, and add a better looking spoiler.
and new wheels of course.

here is a pic of it as almost stock.
 

·
Registered
Joined
·
4 Posts
they are held by screws if i remember correct. you have to disassemble it and unscrew them. the screws that holds that chassis and body together has 6 screws, which is hidden under caps.
Sorry, where is this protection screws? Thank you so much! This is a photo..
 

·
Administrator
Joined
·
6,960 Posts
you will spot them if you look carefully. two in front, two in the sides and two in the rear. remove caps with a small knife or flat screw driver
 
1 - 9 of 9 Posts
Top