DiecastXchange Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
462 Posts
Discussion Starter · #1 ·
I have decided to modify a gt3, non RS version by autoart, and installing parts from my GT3RS, both 996 bodies,
but i first want to know if the shell is off from the same mold ? i mean fair enough if it's slightly wider and i'm
pretty sure of that, but what i'm asking is would the chassis and the interior components fit with little modification?
 

·
Registered
Joined
·
5,254 Posts
I don't have either of these models, but I have done this on UT Porsches and it works OK. I would check to see if the screws holding the chassis on are in the same place and then go from there.

I think they would fit OK.
 
1 - 2 of 2 Posts
Top