DiecastXchange Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
153 Posts
Discussion Starter · #1 ·
Does anybody here have experience in deals application? Recently I have bought the F1 conversion sets but were confused of how to apply. Especially the front cockpit where there were few antennas such as the F2003GA. The Marlboro decal came were in fact no hole. How to apply this Marlboro to this section and put it thru the antenna without destroying the decals?

Please helpppp!!!! :cry :cry :cry
 
G

·
if the antenna and the hole it is mounted in is thin
after decal is applied and dried, make a small hole with a pin the put antenna back in
 
G

·
I don't pay alot of attention to details. So what I did was simply poke the decal thru the antennas while applying it :tongue

Heres a pic:

 
G

·
<{POST_SNAPBACK}>[/post][/right]
Thanks VR :cheers
I must say the GA is one that has to have decals.. or else it wouldnt look right in my opinion.. but I dunno about the F2004.. i know its not out yet.. but i am already planning whether or not to get the decals when they are available :giggle Seems like the 04 could look decent without decals.. just have to wait and see I suppose
 
1 - 7 of 7 Posts
Top