DiecastXchange Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
462 Posts
I use Duplicolor on all the repaints I do. I usually spray a little paint out before I start using it to make sure the nozel isn't blocked at all and theres no build up on it. Occasionally , the nozels from the factory aren't great and leak , be careful of that too. When I start painting a car, I will start pressing the nozel before it gets to the car , in long horizional strokes, about a 1-2" before and after the car. Usually any blockage or problems with the nozel will be aired out before touching the car.
Once I get past the car, I stop and start over.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top