DiecastXchange Forum banner
1 - 11 of 11 Posts
G

·
Discussion Starter · #1 ·
I was so disappointed in my 360 Stradale, that I decided to use it as a donor model. I used the wheels to replace those on a Hot Wheels Enzo.

Adding the wheels were more than just a swap job, my dremel was working over time to say the least.

I had to trim some of the plastic molding down to accommodate the wheels in the back.

In the front, I had to use some make shift extensions.

I wanted the finished model to have the ability to roll, so I had to be careful that aI didn't hack anything up.
 
G

·
Discussion Starter · #2 ·
The stance remains the same as it is impossible to lower a Hot Wheels model.

But it still sits pretty well.
 

·
Registered
Joined
·
8,936 Posts
Nice work Darrick on installing those rims! :nicejob :nicejob :nicejob Plus your pictures look incredibly nice!! I see you've kicked it up a big notch. :cheers :cheers
 
1 - 11 of 11 Posts
Top