DiecastXchange Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter · #1 ·
Next to the Pocher GT2 I have been working on another RC Conversion: An MJX 1:10 Ferrari 430 GT. The basis was very accurate in shape so I decided the take a try. I left it lying around for almost half a year and finished it in the last few weeks.

The basis to start from:



I built a cockpit with the corresponding frames at the back where the engine and the transmission lie:



For the brakes I ordered very thin washers and created a slotted surface (which of course I mounted on the wrong side at the end...):











Dashboard:



As it would have been pretty hard to use carbon fibre properly on the engine-airboxes I used the famous "stocking-technique" (holding the stocking over the object and spray through the mesh). It came out - well - ok. Did this for the first time and from a distance it looks good:



 
1 - 5 of 5 Posts
Top