DiecastXchange Forum banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #1 ·
i was wondering if anyone on here could mould bumpers and dashes etc, i can do 1 part moulds successfully, but that means you always need one flat sied for the open part of the mould, so i need tyo find someone that can do two part moulds (two parts stuck together to get detail on all sides) i use ebolta resin so a silicone mould would be the best option
 
G

·
Discussion Starter · #3 ·
thanx for that, i might give that a go, those tutorials are a good start, and i already have the silicone and resin, its not the same brand but it may work :)
 

·
Registered
Joined
·
8,936 Posts
Hi chups....haven't seen you around for a little while so it's good to see you pop by! :cheers What special project are you working on now?
 
G

·
Discussion Starter · #5 ·
just honing in on some of my skills and trying to improve on them for better overall projects

but i am currently working on a custom PT cruiser (for Holden Kit)
a holden monaro for Ben P,
a modified holden ute
and a few fill in projects when i have some spare time :)
 
1 - 5 of 5 Posts
Top