DiecastXchange Forum banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #3 ·
Like all Maistos, you can just pull the wheel straight off of the hub. It's easier if you take whole wheel assembly off first. This way you can get a good grip and minimize breaking the post that holds the hub in place.
 
G

·
Discussion Starter · #4 ·
<{POST_SNAPBACK}>[/post][/right]
thanks for the feed back...i tried pulling the wheel off the hub...but was very hesitant cause i thought i would break it...ill try when i get some time and post some pics of what i come up with...thanks!!
 
G

·
Discussion Starter · #5 ·
well i got the rims off but pieces that the rims were on are bigget than the holes in the rims that i had planned on using...what do you suggest is the best way to sand down the "axles" that the stock rims were on...they arent really axles though they are just plastic pieces :feedback
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top