DiecastXchange Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
737 Posts
I am very new to the customizing scene, and just purchased a set of custom wheels in hopes of putting them onto my Maisto Viper SRT-10. The wheels currently on the rear of the car are attached by an axle that has two holes that fit over the springs. The custom wheels only have a metal rod to hold them in place. In the front, the situation is similar, except the wheels are connected to the axle as well as the steering wheel, so the car can turn. Is there any way I can put the new wheels on the car using the metal rod? Any help is appreciated. Thanks a lot! :cheers
 

·
Registered
Joined
·
737 Posts
Discussion Starter · #3 ·
Wow, that's perfect gafotes! I should have checked the tutorials section before I posted this. Thanks so much for your help! :cheers :cheers :cheers
 
1 - 3 of 3 Posts
Top