DiecastXchange Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,064 Posts
Discussion Starter · #1 ·
Dear wise forum users

I would like some help with these 2 questions:

1)
Im trying to find wheels that look like these below ,if theres a model with exactly the same design or if theres someone that could 3d print these wheels for me Please advise me where or who can them.
Stanger-20130128-00496.jpg

2)
If theres someone that make decals for me without me providing a pdf image, why? im not good scaling and someone with knowledge would do i better job than me :) but il provide images of the decals and the where they belong on the car.

your assistance will be highly appreciated :)

Kind regards
Someone trying not to mess up a model
 

Attachments

·
Registered
Joined
·
467 Posts
Awesome,i will send you a Pm later this evening !thanks
the more data the better! if you could i`d like to know:

- the horizontal distance from the axle to the edge of the wheel well
- a picture of the axle and measurements so i can design the rims to fit stock parts

get me some clay and i`l make bricks

-
 

·
Registered
Joined
·
1,064 Posts
Discussion Starter · #6 ·
Awesome,i will send you a Pm later this evening !thanks
the more data the better! if you could i`d like to know:

- the horizontal distance from the axle to the edge of the wheel well
- a picture of the axle and measurements so i can design the rims to fit stock parts

get me some clay and i`l make bricks

-
[/quote]
You are an Awesome brick maker lol,
Thanks again!
 
1 - 6 of 6 Posts
Top